Bare Elements Project Sheet

- Contact
- Customer Support
- Social Media
- Events

XXMARIA PURSE PROJECT

BUY MARIA PURSE
BUY PIZZAZZILL
PRINT PROJECT

Supplies
Romance Dot Pizzazzill Paper #17721
Starmist Stripe Pizzazzill Paper #17733
Walnut Harlequin Pizzazzill Paper #17700
Walnut Swirl Pizzazzill Paper #17745
Allison Connors Baby Pink Big Flower Brads #14565
Allison Connors Baby Blue Big Flower Brads #14566
Coordinating ribbon and trims
AccuCut Maria Purse Die #B1071J (Optional)
Paper trimmer, scissors or craft knife/cutting mat
Brown ink
Xyron 900 or glue stick

Instructions
1. Trace and cut out the front and back panels of a Maria Purse or use the coordinating AccuCut Maria Die to cut one panel from Romance Dot Pizzazzill Paper and one panel from Starmist Stripe Pizzazzill Paper.
2. Place the panels one on top of the other with the patterned sides facing up. Using a paper trimmer or a craft knife/ruler, cut the panels into two pieces, one third of the length of the panels, as shown.
3. Switch a blue panel with a pink panel to make a two toned look. Do this for both sides of the purse.
4. Run the panels through a Xyron 900 (double-sided adhesive). Remove the adhesive carrier and attach the panels to the front and back of a Maria Purse
5. Cut 1” strips from Walnut Pizzazzill Paper. Ink the edges with brown ink and apply the strips to the front and back sides of the purse.
Optional: Cover the sides of the purse with coordinating Walnut Pizzazzill Paper.
6. Punch a hole in right side of strip and attach a flower brad.
7. Tie coordinating lengths of ribbon onto the handle.